APIX beehive for 10 frames made of food-grade polystyrene (PPS, foam) with a density of 100 kg per cubic meter.

Set includes: bottom with mesh and entrances, 4 bodies for 145 mm frames, roof

Beehive Specifications

— roof length – 550 mm
— bottom length – 590 mm
— body width – 480 mm

— body length – 590 mm
— internal body length – 450 mm
— internal body width – 380 mm

— feeder 55 x 47.5 x 8 cm
— wall thickness at the thinnest point — 40 mm
— mesh at the bottom of the beehive – 430x176 mm
— polystyrene density — 100kg / m2

Product Description

The bottom has two ventilation holes under the mesh, with the option to install a flag to separate families. There is a groove at the bottom, 22 mm deep, for a standard PPS sheet to close the bees in cold weather (if needed). There are handle recesses. The groove is for dividing the beehive in half, with each half having its own entrance.

The roof of the beehive is 72 mm to 52 mm thick at the narrowest point. It has a slight slope on the sides for water drainage. The roof is heavy and does not require additional wind load.

The body for 145 mm frames is one-piece. Two bodies allow for the placement of 300 mm frames.
The body is 40 mm thick at the narrowest point. The internal size is 450*385 mm.

The body is very strong, allowing you to work with a chisel around t